User manual

3.5.2. Location
Settings: Front Tabletop, Front Ceiling, Rear Tabletop, Rear Ceiling
The image can be flipped to accommodate different projection scenarios as well as screens mounted
upside down.
3.5.3. Optimize for Display
Settings: DVI forced, Optimized, DVI/HDMI
Internally, the display interface processes data at a full ten bits per color. The color depth on the DVI-D
output is determined by the supported standard of the attached monitor or device when set to
DVI/HDMI. For DVI 1.0 and HDMI 1.1/1.2 devices it is 24 bit, for HDMI 1.3 compliant devices it is up to
36 bit.
DVI forced will output with 24 bit color depth irrespective of the supported standard of the attached
monitor.
When the Optimized setting is enabled the output resolution is automatically set to the native screen
resolution of the attached display by reading the EDID of the display.
3.5.4. Default Frame Rate
Settings: 50Hz, 60Hz, Auto
In auto mode the output frame rate follows the input frame rate, when a 50Hz and 60Hz video signal is
detected, the output is repeated at 50Hz and 60Hz. When the input video signal has other than 50Hz or
60Hz (with margin) refresh rate, the output is set to 60Hz. Resolution and actual frame rate is shown in
the status lines of the OSD window under Output Format.
3.5.4. DVI Range
Settings: Default, Limited, Full
When set to Default CEA output modes have limited range, and VESA modes have full range.
Therefore, an incoming limited range mode is either passed through when the output is set to a CEA
output mode or expanded when the output is set to a VESA mode. An incoming full range mode is either
compressed when the output is set to a CEA output mode or passed through when the output is set to a
VESA mode.
If the HDMI/DVI output does not behave as expected, because the HDMI display is not evaluating
AVInfoFrames properly, the range can be changed manually.
A limited video range is only using the following greyscale for video information - 8 Bit System: 0x10 ..
0xEF, 10 Bit System: 0x040 .. 0x03BF, 12 Bit System: 0x100 .. 0xEFF.
3.5.5. Frame Rates
Available Settings: 60 Hz, 50 Hz, 48 Hz, 24 Hz, Auto
In auto mode the output frame rate follows the input frame rate as configured in the Output Config
menu.
Signals with 24Hz, 25H, 48Hz, 50Hz input modes get special treatment, modes with other refresh rates
are displayed at 60Hz.
24Hz input modes will be output at 24Hz if the output resolution is set to either 720p or 1080p and the
Frame Rate setting in the Output Config menu includes 24Hz, otherwise it is displayed at twice the rate
if the Frame Rate setting in the Output Config menu includes 48Hz.
Otherwise a 24Hz input mode is displayed at 60Hz. 48Hz input modes will be output at 48Hz if the
Frame Rate setting in the Output Config menu includes 48Hz.