User manual

3.2.

Introduction

The front panel has keys for OSD menu navigation and input channel selection. OSD navigation is

through two direction keys and a Menu/Enter key

1 – Standby key: When applying power to the unit it starts up. This is indicated by the green On LED

flashing. Once the unit is operational, the On LED is permanently on. By pressing the Standby Key, the

unit is put into standby mode. This is indicated by the red Standby LED being permanently on.

The red Keylocked LED indicates a keypad locking condition issued through the OSD menu. If a key on

the front panel is now pressed an OSD message comes up and displays the multiple key press to be

applied to unlock the front panel keys. (OSD can be disabled)

2 – Input channel selection keys: All input channels can be directly selected. The active channel is

indicated by the red LED above the corresponding channel key being on.

3 – Test Pattern key: Key to directly activate a Test Pattern. Use the up and down keys to toggle trough

the available test patterns or can be selected in the menu system. The LED is switched on when in Test

Pattern mode.

4 – OSD navigational keys: With the Menu key the OSD menu is activated. The up and down keys are

used for OSD menu navigation. To exit the OSD menu or any submenu press the up and down key

simultaneously or navigate to the Exit item and press the menu/enter key. To access a submenu

navigate to it and press the menu/enter key. To apply a change go to the menu item, press the

menu/enter key and make a parameter change with the up and down key. Confirm the change by

pressing the Menu/enter key. This will also bring you back to the submenu.

With the following multiple key presses further functions can be applied:

Keypad unlock: Menu and Up and Down

Input Mode reset: Menu and VGA

Factory reset: Menu and DVI

Set output mode to 720p: Menu and HDMI

The back panel features all input and output connectors, communication ports and the power supply

connector.

1 – Digital audio output 2 – HDMI input 3 – DVI-D and VGA input 4 – DVI/HDMI output

5 – USB port 6 – TCP/IP port 7 – RS232 port 8 – Power supply connector