User manual

3.10.5. Menu Settings
This menu provides items to change the menu position and menu display time, the time after which the
OSD is switched off again with no user interaction. OSD Messages can be activated and deactivated.
The menu language can be altered and the keypad can be locked. Either all keys or the menu and
menu navigational keys can be locked. To unlock the keypad a combination of keys has to be pressed
at the same time. The locking of the keyboard is accompanied by a message: Keypad is locked. Press
Menu and Up and Down to unlock. When successfully unlocking the keypad the message shows up:
Keypad unlocked.
3.10.6. Network Settings
The Network Settings menu allows to configure the VP-793 TCP/IP address. Under Address Type a
static or DHCP leased address can be chosen. The static address and Netmask need to be entered
manually.
The Network Settings menu has a section with information on the DHCP Status and IP address
assigned to the board, as well as the fixed MAC Address programmed into the VP-793 . The DHCP
status is Off when static assignment is used or it displays an address when DHCP has leased an
address accordingly or it is None assigned if the lease was not successful.
Note: When changing from DHCP to Static mode or vice versa it is strongly recommended that VP-793
is powered down after such a change, then powered back up, so that it is properly recognised by other
devices on the network.
3.10.7. Factory Defaults
This button let you restore all settings to the default values of the VP-793 , thus, provide a means to get
back to a known (good) system state. The user is asked to confirm prior to actual restore.