Instruction Manual

Your VS-169TP 16x9 CAT 5 Matrix Switcher
9
9
Table 2: VS-169TP 16x9 CAT 5 Matrix Switcher Rear Panel Functions
#
Feature
Function
16
LOCAL INPUTS
AUDIO IN 3.5mm Mini Jack Connect to the local audio source (for local inputs 1 and 2)
17 UXGA IN 15-pin Connector Connect to the UXGA source (for local inputs 1 and 2)
18 UXGA SELECT Pushbuttons Select the remote or LOCAL (built-in) receiver for input 1 and
input 2 for UXGA
19 AUDIO/RS-232 SELECT
Pushbuttons
Select the remote or LOCAL (built-in) receiver for input 1 and
input 2 for AUDIO and RS-232
20 RS-232 IN 9-pin D-sub
Connectors
Connect to the RS-232 source for local inputs 1 and 2
21 IN (1 to 16) RJ-45 Connectors Connect to the LINE OUT RJ-45 connectors of the remote
transmitters via CAT 5
22 OUT (1 to 8) RJ-45 Connectors Connect to the LINE IN RJ-45 connector of the remote receivers
via CAT 5
23
LOCAL OUTPUTS
RS-232 OUT 9-pin D-sub
Connectors
Connect to the RS-232 local acceptor
24 EQ. Trimmer Adjusts the cable compensation equalization level for the local
built-in receiver
25 LEVEL Trimmer Adjusts the output signal level for the local built-in receiver
26 LINK LED Illuminates when the local receiver receives the correct input signal
27 UXGA OUT 15-pin Connector Connects to the UXGA local acceptor
28 AUDIO OUT 3.5mm Mini Jack Connects to the analog audio local acceptor
29 HS Switch Slide down
1
30
to set the H SYNC to negative polarity (-);
slide up to set the H SYNC to positive polarity (+)
VS Switch Slide down
1
to set the V SYNC to negative polarity (+);
slide up to set the V SYNC to positive polarity (-)
31 POWER Switch Switch for turning the unit ON and OFF
32 REMOTE IR 3.5mm Mini Jack
2
Connect to an external IR receiver unit for controlling the machine via
an IR remote controller (instead of using the front panel IR receiver)
3
33 POWER IN with fuse
AC connector enabling power supply to the VS-169TP
34
CONTROL
FLASH MAIN Push in
4
10.1
to upgrade the switcher microcontroller to the latest
Kramer firmware (see
Section ), or release (the factory
default) for normal operation
35 RS-232 IN 9-pin D-sub Port Connect to the PC or the remote controller
36 RS-232 OUT 9-pin D-sub Port Connects to the RS-232 IN 9-pin D-sub F port of the next unit in
the daisy-chain connection
37 RS-485 Terminal Block Port Pins B (-) and A (+) are for RS-485; connect pin G to the cable
shield (if required)
38 SETUP DIP-switches For setup of the unit (see Section 6.2)
39 ETH FLASH Pushbutton Push in
4
to upgrade the ETH FLASH firmware version (see Section
10.2), or release (the factory default) for normal operation
40 ETHERNET Connector Connects to the PC or other Serial Controller through computer
networking LAN
1 By default, both switches are set down (for a negative V SYNC and H SYNC polarity)
2 Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this opening
3 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the VS-169TP (only if the internal
IR connection cable has been installed)
4 Using a small screwdriver, if required