Instruction Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Connecting the VS-169TP 16x9 CAT 5 Matrix Switcher

5.1 Wiring the CAT 5 LINE IN / LINE OUT RJ-45 Connectors

Table and 3 Figure define the UTP/FTP3

Table 3: CAT 5 PINOUT

CAT 5 PINOUT, using a straight

pin to pin cable with RJ-45 connectors:

Figure 3: CAT 5 PINOUT

81 2

5 7

8632

EIA /TIA 568A EIA /TIA 568B

Wire Color

1 Green / White 1 Orange / White

2 Green 2 Orange

3 Orange / White 3 Green / White

4 Blue 4 Blue

5 Blue / White 5 Blue / White

6 Orange 6 Green

7 Brown / White 7 Brown / White

8 Brown 8 Brown

Pair 1 4 and 5 Pair 1 4 and 5

Pair 2 3 and 6 Pair 2 1 and 2

Pair 3 1 and 2 Pair 3 3 and 6

Pair 4 7 and 8 Pair 4 7 and 8

6 Connecting the VS-169TP 16x9 CAT 5 Matrix Switcher

To connect the VS-169TP as shown in the example in Figure 4, do the

following

1. For signal sources that are located near the VS-169TP (the LOCAL

INPUTS):

 A UXGA source (for example, the graphics output on a laptop) to the

UXGA IN 1 15-pin HD (F) connector

 An audio source to the AUDIO IN 1 3.5mm mini jack

, for example,

using a Kramer C-GMA/GMA cable (VGA 15-pin HD (M) +Audio

jack to VGA 15-pin HD (M) +Audio jack)

 An RS-232 cable with a 9-pin D-sub connector to the PC or controller

at one end, and a 9-pin D-sub connector at the other end to the

RS-232 IN 1 and/or the RS-232 IN 2.

1 FTP means Foiled twisted pair

2 Switch OFF the power on each device before connecting it to your VS-169TP. After connecting your VS-169TP, switch on

its power and then switch on the power on each device

3 You can connect UXGA IN 1 and/or UXGA IN 2

4 You can connect AUDIO IN 1 and/or AUDIO IN 2

5 Not supplied. The full list of Kramer cables is on our Web site at http://www.kramerelectronics.com. Alternatively, you can

connect an UXGA source to the UXGA IN 15-pin HD (F) connector, and a separate audio source to the AUDIO IN 3.5mm

mini jack