Instruction Manual

Connecting the VS-169TP 16x9 CAT 5 Matrix Switcher
13
13
2. For signal destinations that are located near the VS-169TP (the LOCAL
OUTPUT):
 The UXGA OUT 15-pin HD (F) connector to the UXGA monitor
 The AUDIO OUT 3.5mm mini jack to the self-powered speaker
system
 An RS-232 cable with a 9-pin D-sub connector to the RS-232 OUT at
one end, and a 9-pin D-sub connector at the other end to the RS-232
IN of the controlled unit
 If required, adjust the cable compensation equalization level and/or
video output signal level with a screwdriver
 If necessary, set the H SYNC and V SYNC switches
1
3. For signal sources that are located at a distance from the VS-169TP,
connect the remote transmitters/receivers as follows:
 Connect up to 16 transmitters
2
(for example, the Kramer
TP-125EDID XGA / Audio / Data Line Transmitter
3
 Connect up to eight receivers
)
2
(for example, the Kramer TP-126
UXGA / Audio / Data Line Transmitter
3
)
4. Connect the 12V DC power supply to the power socket and connect the
adapter to the mains electricity on both the transmitters and the receivers.
5. If required, connect a PC or controller to the RS-232 ports (see
Section
7.1) or the RS-485 port (see 7.2Section ) or the ETHERNET port (see
7.3Section
6. If required, set the DIP-switches (see
).
Section 6.2
7. Connect the power cord
).
4
1 By default, both switches are set down (for negative V SYNC and H SYNC polarity)
.
2 You do not have to connect all the inputs and outputs
3 Download up-to-date Kramer user manuals from our Web site at http://www.kramerelectronics.com
4 We recommend that you use only the power cord that is supplied with this machine