Manual

VS-42HN - Operating the VS-42HN 4x2 HDMI Matrix Switcher
11
6 Operating the VS-42HN 4x2 HDMI Matrix
Switcher
This section describes:
 Acquiring the EDID (see Section 6.1)
 Resetting to the default EDID (see Section 6.2)
 Storing and recalling switch settings (see Section 6.3)
 Switching Between Protocol 2000 and Protocol 3000 (see Section 6.4)
 Connecting to the VS-42HN via RS-232 (see Section 6.5)
 Connecting to the VS-42HN via Ethernet (see Section 6.6)
 Upgrading the firmware (see Section 6.6.1)
6.1 Acquiring the EDID
You can acquire the EDID from OUT 1 and/or OUT 2 and copy it to any of the four
inputs, or reset to the default EDID. The EDID is acquired at once for all the inputs,
according to the status of the selector buttons.
To acquire or change the EDID of one or both new output displays:
1. Connect the required acceptor to the output from which you want to acquire
the EDID.
2. Connect the power supply.
3. Press the EDID button and hold it for 3 seconds.
The four buttons that switch to the output from which you are acquiring the
EDID show their current state:
 Input buttons that do not illuminate, store the default EDID
 Input buttons that flash store the previously acquired EDID from the
OUT 1 or OUT 2 acceptor