User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VS-48HDxl 3G HD/SD SDI 4x8 Matrix Switcher
10
6 Connecting the VS-48HDxl 3G HD/SD SDI 4x8 Matrix Switcher
To connect the VS-48HDxl 3G HD/SD SDI 4x8 Matrix Switcher, as
illustrated in the example in Figure 2, do the following
1
:
1. Connect up to four SDI sources to the SDI INPUT BNC connectors (for
example, an HD/SD SDI camera to input 1 and a 3G HD video server to
input 4).
2. Connect the SDI OUTPUT BNC connectors to up to
2
eight SDI acceptors
(for example, output 1 to a Preview display, and output 8 to an HD SDI
mixer).
3. Set the dipswitches (see section 6.3).
4. If required
3
, connect:
 A Genlock source to the GENLOCK BNC connector
 The LOOP BNC connector to the GENLOCK connector of the next
unit in the line, and release the TERM button for looping
4
5. Connect a PC and/or controller (if required), to the:
 RS-232 port (see section 6.4), and/or
 RS-485 port (see section 6.5), and/or
 ETHERNET connector (see section 6.6)
6. If required
3
, connect a remote dry contact switch (refer to section 6.9).
7. Connect
3
the power cord
5
.
1 Switch OFF the power on each device before connecting it to your VS-48HDxl. After connecting your VS-48HDxl, switch
on its power and then switch on the power on each device
2 When only one output is required, connect that output, and leave the other outputs unconnected
3 Not illustrated in Figure 2
4 Pushed in terminates the input. Release when the input extends to another unit
5 We recommend that you use only the power cord that is supplied with this machine