User manual
Connecting the VS-48HDxl 3G HD/SD SDI 4x8 Matrix Switcher
17
6.7 Switching Genlocked Video Signals
The genlock feature lets you switch genlocked video signals according to
timing of the GENLOCK reference input
1
.
Connect the GENLOCK cable.
If the HD input signal
2
that is connected is one of the following, it is necessary
to set it up as follows:
1080i@60Hz: press and hold INPUT 1 button for 3 seconds. The
button will flash
3
to indicate that the set up was completed
1080i@50Hz or 720p@50Hz: press and hold INPUT 2 button for 3
seconds.
The button will flash
3
to indicate that the set up was completed
720p@60Hz: press and hold INPUT 3 button for 3 seconds.
The button will flash
3
to indicate that the set up was completed
When turning the machine ON, the appropriate button will flash to indicate
the latest setup (last setup is saved).
6.8 Controlling via ETHERNET
You can connect the VS-48HDxl via the Ethernet, using a crossover cable
(see section 6.8.1) for direct connection to the PC or a straight-through cable
(see section 6.8.2) for connection via a network hub or network router
4
.
6.8.1 Connecting the ETHERNET Port directly to a PC (Crossover Cable)
You can connect the Ethernet port of the VS-48HDxl to the Ethernet port on
your PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP Address of the VS-48HDxl during the initial configuration
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select Properties.
1 According to SMPTE RP-168. The sources must be genlocked to the GENLOCK input in order to switch cleanly
2 The unit will detect automatically when SD-SDI inputs are used
3 If a change is made to the resolution or refresh rate. The button will not flash if the new timing is the same as that
previously selected
4 After connecting the Ethernet port, you have to install and configure your Ethernet Port and also install the COM Port
Redirector. For detailed instructions, see the “ Ethernet Configuration (Lantronix) guide.pdf” file in the technical support
section on our Web site: http://www.kramerelectronics.com