User manual

VS-48HN - Operating the VS-48HN 4x8 HDMI Matrix Switcher

6 Operating the VS-48HN 4x8 HDMI Matrix

Switcher

This section describes:

 Switching an input to an output (see Section 6.1)

 Acquiring the EDID (see Section 6.2)

 Storing and recalling switch settings (see Section 6.3)

 Changing the port switching speed (see Section 6.4)

 Setting HDCP on or off (see Section 6.5)

 Resetting the VS-48HN IP parameters (see Section 6.6)

 Switching between Protocol 2000 and Protocol 3000 (see Section 6.7)

 Connecting to the VS-48HN via RS-232 (see Section 6.8)

 Connecting to the VS-48HN via Ethernet (see Section 6.9)

 Upgrading the firmware (see Section 6.10)

6.1 Switching an Input to an Output

To switch an input to an output:

 Press an output button followed by an input button to switch the selected

input to the selected output

6.2 Acquiring the EDID

You can acquire the EDID from any of the following:

 One output set to one or more of the four inputs (see Section 6.2.1)

 Different outputs set to different inputs (see Section 6.2.2)

 The default EDID (see Section 6.2.3)

Note: Attempting to acquire the EDID from an output that does not have a display

device connected to it results in the default EDID being acquired.