User manual

VS-48HN - Operating the VS-48HN 4x8 HDMI Matrix Switcher

6.8 Connecting via RS-232

You can connect to the VS-48HN via an RS-232 connection using, for example, a

PC. Note that a null-modem adapter/connection is not required.

To connect to the product via RS-232:

 Connect the RS-232 9-pin D-sub on the rear panel of the VS-48HN via a

9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5

need to be connected) to the RS-232 9-pin D-sub port on your PC

6.9 Connecting via Ethernet

You can connect to the VS-48HN via Ethernet using either of the following methods:

 Directly to the PC using a crossover cable (see Section 6.9.1)

 Via a network hub, switch, or router, using a straight-through cable (see

Section 6.9.2)

After connecting the VS-48HN to the Ethernet port, configure your local Ethernet

port by following the instructions in the Kramer Ethernet Configuration User Guide

available from http://www.kramerelectronics.com/support/product_downloads.asp.

Note: If you want to connect via a router and your IT system is based on IPv6,

speak to your IT department for specific installation instructions.

6.9.1 Connecting the Ethernet Port Directly to a PC

You can connect the Ethernet port of the VS-48HN directly to the Ethernet port on

your PC using a crossover cable with RJ-45 connectors.

This type of connection is recommended for identifying the VS-48HN

with the factory configured default IP address.

6.9.2 Connecting the Ethernet Port via a Network Hub or Switch

You can connect the Ethernet port of the VS-48HN to the Ethernet port on a

network hub or using a straight-through cable with RJ-45 connectors.

6.10 Upgrading the Firmware

For instructions on upgrading the firmware see “Upgrading the VS-48HN Firmware

Using the STC Software”.