User manual

VS-62H - Connecting the VS-62H 6x2 HDMI Matrix Switcher

2. Connect the two OUT HDMI connectors to up to two HDMI acceptors, (for

example, LCD displays with built-in speakers).

3. If required, connect a PC/controller to the RS-232 port (see Section 6.1)

and/or the Ethernet port (see Section 6.2).

4. Connect the power adapter to the device and plug the power adapter into

the mains electricity (not shown in Figure 3).

5. If required, acquire the EDID (see Section 8.1).

6.1 Connecting a Serial Controller to the VS-62H via RS-232

To connect a serial controller to the VS-62H:

 From the RS-232 9-pin D-sub serial port on the serial controller connect:

 Pin 2 to the TX pin on the VS-62H RS-232 terminal block

 Pin 3 to the RX pin on the VS-62H RS-232 terminal block

 Pin 5 to the GND pin on the VS-62H RS-232 terminal block

6.2 Connecting to the VS-62H via Ethernet

You can connect to the VS-62H via Ethernet using either of the following methods:

 Directly to the PC using a crossover cable (see Section 6.2.1)

 Via a network hub, switch, or router, using a straight-through cable (see

Section 6.2.2)

Note: If you want to connect via a router and your IT system is based on IPv6,

speak to your IT department for specific installation instructions.

6.2.1 Connecting the Ethernet Port Directly to a PC

You can connect the Ethernet port of the VS-62H directly to the Ethernet port on

your PC using a crossover cable with RJ-45 connectors.

This type of connection is recommended for identifying the VS-62H

with the factory configured default IP address.