User manual

16
VS-62H - Principles of Operation
7.3 EDID Operation
The VS-62H has a default EDID (see Section 14) stored on all inputs. This EDID
can be exchanged for either:
 A custom EDID which is uploaded to one or more inputs using Protocol 3000
commands (see Section 15.2)
–OR–
 The EDID of a display device connected to an output by using either the
front panel buttons (see Section 8.2), a Protocol 3000 command, or the Web
pages
The EDID is non-volatile and the last valid EDID is used when the device is
powered up.
7.4 Step-in Functionality
The VS-62H can function as a step-in switcher when connected to a suitable
HDMI transmitter, (for example, the SID-X3N), using the correct HDMI cable with
HEC support.
Use the Web pages (see Section 10.2.2) to assign remote device button actions.
The default button actions are shown in the following table. Up to three buttons
can be active at the same time.
Command
Action
Echo
Allows a connected controller to be programmed to perform a variety
of tasks triggered by the user buttons, such as, room control, (lights,
screen, and so on)
Out1
Step in current input to Output 1
Out2
Step in current input to Output 2