User manual

22
VS-62H - Configuring and Maintaining the VS-62H
9.2 Resetting the VS-62H to Factory Default Settings
To reset the device to factory default settings:
1. Power off the device.
2. Press and hold down the Reset button on the rear panel.
3. While holding down the Reset button, power on the device.
4. Wait a few seconds and release the button.
The device is reset to its factory settings.
9.3 Upgrading the Firmware
The VS-62H can be upgraded via any of the following:
 Mini USB
 RS-232
 Ethernet
For instructions on upgrading the firmware see “K-Upload Software”.