Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your VS-808YC 8x8 s-Video / Audio Matrix Switcher
6
Table 2: Rear Panel VS-808YC 8x8 s-Video / Audio Matrix Switcher Features
# Feature Function
15 AUDIO INPUTS Terminal Block
Connectors
Connect to the balanced stereo audio sources (from 1 to 8)
16 VIDEO INPUTS 4-pin
Connectors
Connects to the s-Video sources (from 1 to 8)
17 VIDEO OUTPUTS 4-pin
Connectors
Connects to the s-Video acceptors (from 1 to 8)
18 DIP-switches DIP-switches for setup of the unit (1, 2, 3 and 4 are for setting the
Machine #; 8 is for RS 485 Termination)
19 AUDIO OUTPUTS Terminal
Block Connectors
Connect to the balanced stereo audio acceptors (from 1 to 8)
20 RS-232 9-pin D-sub Port Connects to the PC or the Remote Controller
21 REMOTE IR Opening
1
Connects to an external IR receiver unit for controlling the machine via
an IR remote controller instead of using the front panel IR receiver
2
22 FLASH PROG Button Push in
3
for “Program” to upgrade to the latest Kramer firmware
(see section 9), or release for Normal (the factory default)
23 RS-485 Terminal Block Port Pin G is for Ground connection; Pins B (-) and A (+) are for RS 485
24 Power Connector with Fuse AC connector enabling power supply to the unit
Figure 2 and Table 3 define the Flash button on the underside of the VS-808YC:
Figure 2: VS-808YC Underside Flash Program Button
Table 3: VS-808YC Underside Flash Program Button
# Feature Function
1 Flash Program
Reset Button
Push in
4
for “Reset” (see section 9), or release for Normal (the factory default)
1 Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this opening
2 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed)
3 Using a thin screwdriver if required
4 Using a screwdriver if required