Owner manual

102
K-Config - Adding Actions to a Trigger
9.2.1 Adding a Table Action
After creating tables via the Driver Manager (see Section 5.5.4) you can use it in the action editor Port Command list:
Figure 183: The Table Port Command
Select the:
 Table (Output_Volume)
 Select the RC device whose LEDs should behave as defined in the table (RC-63DL). Select None if you do not
want the LEDs to behave as defined in the commands table
 Set the behavior of the table commands to go gradually up, down, or set to a specific value. If you click Set, you
can choose a specific volume level (see Figure 184):
Figure 184: The Table Port Command – Setting a specific Volume Level