System Guide

PA-120Z / PA-240Z Quick Start
P/N:
29 0 0 - 3 0 0 8 0 2 QS
Rev:
5
Scan for full manual
PA-120Z / PA-240Z Quick Start Guide
This guide helps you install and use your PA-120Z / PA-240Z for the first time.
Go to www.kramerav.com/downloads/PA-120Z to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
PA-120Z / PA-240Z 120W / 240W Power Amplifier
4 Rubber feet
1 Power cord
1 Quick start guide
Step 2: Get to know your PA-120Z / PA-240Z
#
Feature
Function
1
ON LED
Lights green when powered on, orange when in standby.
2
INPUT 1 LED
Lights green when a signal is present on input 1.
3
INPUT 2 LED
Lights green when a signal is present on input 2.
4
MUTE
Lights red when the output is muted, off when unmuted.
5
CLIP LED
Lights red when the signal is clipped on the output and creating distortion.
(When clipping is detected, lower the volume until the LED turns off.)
6
PROTECT LED
Lights red in case of over current / short / overheat.
The device powers down until operation conditions are corrected and then powers up
again.