User's Manual
Table Of Contents
- Introduction
- Defining the PA-240Z 240W Power Amplifier
- Connecting the PA-240Z
- Operating the PA-240Z
- Using the Embedded Web Pages
- Technical Specifications
- Protocol 3000
Kramer Electronics Ltd.
PA-120Z, PA-240Z – Connecting the PA-240Z
11
6. Select Use the following IP Address for static IP addressing and fill in the details as
shown in Figure 12.
For TCP/IPv4 you can use any IP address in the range 192.168.1.1 to 192.168.1.255
(excluding 192.168.1.39) that is provided by your IT department.
Figure 12: Internet Protocol Properties Window
7. Click OK.
8. Click Close.
Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the PA-240Z to the Ethernet port on a network hub or
using a straight-through cable with RJ-45 connectors.
Control Configuration via the Ethernet Port
To control several units via Ethernet, connect the Master unit (Device 1) via the Ethernet port
to the Ethernet port of your PC. Use your PC provide initial configuration of the settings (see
Connecting PA-240Z via the Ethernet Port on page 9).