User's Manual

Kramer Electronics Ltd.
PA-120Z, PA-240Z – Operating the PA-240Z
12
Operating the PA-240Z
This section describes the following operations:
• Setting the DIP-Switches on page 12.
• Adjusting the Master Volume on page 12.
Setting the DIP-Switches
By default, the DIP-switches are set to Hi-Z and 100V.
DIP-
Switch #
Setting
Note
1
Set to Hi-Z for high impedance
configurations.
Use when connecting mono speakers in daisy-
chain.
Set to Lo-Z for low impedance
configurations.
Use when connecting to a single pair of
speakers, one to the left and one to the right.
2
When in Hi-Z, set either to 70V or 100V
according to your requirements.
Adjusting the Master Volume
Use the VOLUME trimmer on the rear panel to set the maximum level for the speaker
output speaker output. Adjust the master volume (speaker output) via the web pages, see
Setting the Master Volume and Balance on page 16.