User's Manual

Kramer Electronics Ltd.
PA-120Z, PA-240Z – Using the Embedded Web Pages
15
Setting the Speaker Output Parameters
Use the Speaker Output page to set the speaker input signals mixing and the output
parameters.
PA-240Z enables automatically setting the line level output parameters according to the speaker
output parameters (see Setting the Line Level Output Parameters on page 17).
The Speaker Output Mixer enables performing the following operations:
• Mixing the Input Signal Levels on page 15.
• Setting Equalization Levels on page 16.
• Setting the Master Volume and Balance on page 16.
Mixing the Input Signal Levels
The indication buttons next to Input 1 and Input 2 appear green when there is an active signal on
that input.
To set the Mixing Level:
1. In the Navigation pane, click Speaker Output. The Speaker Output page appears.
Figure 15: Speaker Output Page
2. In the Mix column, use the sliders to set the mixing level for each input or enter their
value below the sliders.
3. Set the High-Pass Filter ON or OFF to cut-off frequencies lower than 70Hz.
To save energy, enable the High-Pass Filter when outputting soft background music or vocal
sounds.