User's Manual

Kramer Electronics Ltd.
PA-120Z, PA-240Z – Using the Embedded Web Pages
16
Setting Equalization Levels
We recommend that you first set the frequencies, then the Q and finally the gain for the Bass
Mid and Treble ranges.
To set EQ levels:
1. In the navigation pane click Speaker Output. The Speaker Output page appears.
2. In the EQ column set the following:
▪ Set the Bass [60Hz, 80Hz, 100Hz or 200Hz] Mid [500Hz, 1kHz, 1.5kHz or 2.5kHz]
and Treble [10kHz, 12.5kHz, 15kHz or 17.5kHz] frequency.
▪ Set the Bass, Mid and Treble Q-Factor [0.1 to 16].
The lower the Q value, the higher the bandwidth.
▪ Use the sliders to set Bass, Mid and Treble equalization or enter their value below
the sliders.
Setting the Master Volume and Balance
The maximum master volume level of the speaker output is set via the trimmer on the rear
panel, see Adjusting the Master Volume on page 12.
In the Master Volume column:
• Use the slider to set the speaker audio level.
• Click to mute/unmute the output volume.
• Set the left right balance on the speaker output.