User's Manual
Table Of Contents
- Introduction
- Defining the PA-240Z 240W Power Amplifier
- Connecting the PA-240Z
- Operating the PA-240Z
- Using the Embedded Web Pages
- Technical Specifications
- Protocol 3000
Kramer Electronics Ltd.
PA-120Z, PA-240Z – Using the Embedded Web Pages
20
Changing the Ethernet Settings
To change the Ethernet settings, if required:
1. In the Navigation pane, click Device Settings. The Device Settings page appears:
Figure 18: Device Settings Page
2. Set DHCP to ON or OFF.
3. If DHCP is set to OFF, change any of the parameters (IP Address, Netmask and/or
Gateway).
4. Click Set.
After changing the IP number, reload the web page with the new IP address.
After changing the Subnet mask you need to restart the PA-240Z.
If DHCP is checked, reload the web page with the new IP address.
5. Set the UDP and TCP port numbers and click Set.