Spec Sheet

WP-571
HDMI HDCP 2.2 Wall Plate Transmitter over
PoC Long−Reach DGKat (EU, UK, US−D)
|HDMI |HDCPCompliant |DGKat |KramerCore
|HDCP2.2Compatible
The WP−571 is a PoC DGKat™ wall plate transmitter
for HDMI signals. The WP−571 converts an HDMI
signal to a DGKat™ twisted pair signal that it
transmits to a WP−572
FEATURES
Max. Data Rate-4.95Gbps (1.65Gbps per graphic channel)
HDTV Compatible
HDCP Compliant
DGKat™ Signal Integration-Kramer’s unique technology for converting TMDS as well as control and
communication to signals that run over twisted pair cables
HDMI Support-HDMI Uncompressed Audio Channels, Dolby TrueHD, DTS−HD
3D Pass-Through
System Range-Up to 90m (295ft) at 1080i @60hz or up to 70m (230ft) at 1080p @ 60hz when using
Kramer DGKat cables.
Note: Transmission range depends on the signal resolution, graphics card and display used. If using
third–party shielded CAT cables, both ends of the shield must be soldered to the connectors for the
products to function properly
EDID PassThru-Passes EDID signals between the source and display
Active Power Indication-The ON LED lights red when receiving power only, orange when either input
or output and power are attached, and green when both an active input and output are attached
Power Connect™ System-A single connection to the transmitter or the receiver powers the system
when the devices are within 90m (295ft) of each other
Dimensions-3.3cm x 3.6cm x 10.4cm (1.3" x 1.42" x 4.1") W, D, H
