Manual

13
Motor protection switch
The motor is protected from overload by a motor protection switch, which cuts out the
motor in the event of overload. However should the switch trip frequently, the cause of
the malfunction should be located and rectified (see page 40).
Replacements and inspection work should only be
performed by qualified persons when the machine is
disconnected from the power supply, i.e. with plug pulled
out from the electrical socket.
High pressure hose and spray device
The high pressure hose and spraying device supplied with the machine are made of high
grade material, they are also optimized for the machine and marked as required by the
appropriate regulations. (max. hose length 20 m)
If replacement parts are required, only such parts that are
authorized by the manufacturer may be used. The warran-
ty is automatically void if spare parts of third-party provi-
ders are used! The high pressure hose and spray device
must be connected in a pressure-tight manner (without
leakage).
The high pressure hose may not be driven over, pulled
excessively, or twisted. The hose may under no circum
-
stances be pulled over sharp edges. Defective high-pres-
sure hoses must not be repaired (acc. to DIN 20022) but
have to be replaced by new hoses appoved by the
manufacturer.
Operate high-pressure cleaner in horizontal position only.
Never direct the high-pressure jet at people or animals.
Never direct the water jet at power sockets or any other electri-
cal installations!
Explanatory symbols afxed to the high-pressure cleaner
The high-pressure cleaner may only be operated in horizon-
tal position!