User`s manual

www.kraun.it9
User’s Manual
Click the Rescan button to refresh the list at any time. Highlight an SSID
and click the Connect button to connect to an available network.
3.4 Statistics
The Statistics tab shows receiving and transmitting statistical informa-
tion for the following receive and transmit diagnostics for frames re-
ceived by or transmitted to the wireless network adapter. Click the Reset
Counter button to reset the count of the statistics information.
Figure 3.12 Statistics tab
3.5 Advanced
On this Screen, you can configure the WEP key or view the configured
WEP key.
Figure 3.13 Advanced
• Wireless mode - Displays the wireless mode, either 802.11B/G mix
or 802.11B only.
• B/S Protection - There are three options: either Auto or Enable, or
Close.
• TxRate - Shows the current Transfer rate.
• TxBURST - It can translate more data when it enable.
• Fast Roaming at - Roaming will disable when Transmit Power is be-
low some dBm.
• Turn off RF - The wireless radio of this adapter can be enabled or
disabled. You can turn the wireless radio off by selecting the check-
box.
• Apply - Click the Apply button to save the current setting.
3.6 About
This screen displays some information about this adapter, including
Driver Date, Driver Version, Utility Date, Utility Version, MAC Address, IP
Address, SubMask, Power Save mode and Preamble.
• Utility Version - The version of this utility.
• Utility Date - The creation date of this utility.
• Driver Version - The version of the wireless network adapter driver.
• Driver Date - The creation date of the wireless network adapter driv-
er.
• EEPROM Version - The version of this EEPROM.
• IP Address - The IP address of the wireless network.
• Phy_Address - The MAC address of the wireless network adapter.
• SubMask - The subnet mask of the wireless network.
• Default Gateway - The default gateway of the wireless network.
Figure 3.14 About
3.7 An example for application
Suppose you have an installed and using AP, the SSID is Kraun and it
adopts 64-bit encryption with the key 0123456789. To establish a con-
nection with this AP, you should follow these steps below:
1. Launch Kraun KR.XC Wireless Utility.
2. Click the Profile tab of the utility and click the New button on the
screen that appears.
3. The Profile configuration screen will appear, please enter Test for the
Profile Name, Kraun for the SSID, select Infrastructure for the Network
Mode, select WEP for the Data Encryption and enter 0123456789 for
Network key.
4. Click OK to save this profile.
5. Click Apply on the Profile screen. The utility will establish a connection
with this AP by configured profile.