Installation Guide

8
Trouble-Shooting
If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps:
Leakage under the faucet
handle
Bonnet nut has come loose. Remove the index. Loosen set screw with
hex wrench. Remove the handle. Unscrew
cap (by hand only). Tighten bonnet nut
with an adjustable wrench.
Aerator drips or has inconsistent
water flow pattern
Aerator is dirty or not
seated properly.
Unscrew aerator with aerator wrench and
clean out debris.
Care & Maintenance
* To keep the product clean & shining, follow the steps below:
1. Rinse with clean water & dry with a soft cloth
2. Do not clean with soaps, acid, polish, abrasives or harsh cleaners
3. Do not use cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
* This installation manual is subject to change without further notice.
Water does not shut off
completely
Cartridge may need to be
adjusted or replaced.
Remove the index. Loosen set screw with
hex wrench. Remove the handle. Unscrew
cap (by hand only). Tighten bonnet nut
with an adjustable wrench. Remove the
cartridge. Check for cracks.
There is leaking from the
sink drain at the base of
the sink
The sink has a rough or
irregular surface.
Apply additional silicone sealant to the
beveled side of the drain flange. Retighten
and test for leaks.
ACID
There is a low flow of water
The screen filter in the hose
connectors is dirty.
Turn off the water supply at water valve
and unscrew the hose connectors from
water supply lines. Clean the screen
in the water lines with hot water, removing
any debris or calcium build up.
PROBLEM CAUSE ACTION