Instructions / Assembly

R U

Product Description and Measurements

Installation Instruction

Prior To Installation Steps

1. Unpack your new product and ensure that all the parts are contained in the packaging.

Keep the product in its original box until you ready to install it.

2. Shut off the water supply if replacing a previously-installed faucet.

3. Observe all plumbing and building codes in your area.

4. It is recommended that installation of the product be done by a professional plumber.

Thank You

Stainless Steel Soap Dispenser

Dear Valued Customer,

Kraus would like to take this opportunity to thank you for purchasing Kraus products. It is our sincere

hope that you are completely satisfied with your new purchase. We welcome any questions or comments

you may have and look forward to assisting you in the future.

Sincerely,

Kraus customer service department.

MODEL-KSD-20

PAGE 1
S MODEL-KSD-20 Product Description and Measurements AU Installation Instruction Stainless Steel Soap Dispenser Thank You Dear Valued Customer, Kraus would like to take this opportunity to thank you for purchasing Kraus products. It is our sincere hope that you are completely satisfied with your new purchase. We welcome any questions or comments you may have and look forward to assisting you in the future. KR Sincerely, Kraus customer service department. Prior To Installation Steps 1.
PAGE 2
S MODEL-KSD-20 Roughing-In Dimensions AU 4 ½’’ 1’’ Neck KR 12’’ 11 1/8’’ 2’’ Pump Washer Ring Body Dispenser 2’’ Contact us toll-free at 1-800-775-0703; or visit our website at www.kraususa.com.
PAGE 3
S MODEL-KSD-20 Installation Instructions Installation Instructions Pump AU Pump Step 1- Hold the neck and pump then unscrew the body dispenser. Step 2- Unscrew the ring from the neck leaving the washer in place. Counter top Neck Step 3- Insert the pump, along with the neck and washer through the counter top. Ring Step 4- Screw on the ring from underneath the counter top onto the neck. Make sure the flat side is facing up towards the pump.