Installation Guide

Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly,
take the following corrective steps:
Leakage under the handle.
PROBLEM CAUSE ACTION
Bonnet nut (12) has
come loose.
Remove the index. Loosen screw with hex
wrench (21). Remove the handle. Unscrew
cap (13) (by hand only). Tighten bonnet
nut (12) with an adjustable wrench.
The aerator has an irregular
or reduced water flow.
The aerator is dirty or
misfitted.
Remove the aerator and check for
debris. Ensure that the rubber washer is
properly installed.
11
Water will not shut off
completely.
Cartridge may need to be
adjusted or replaced.
Remove the index. Loosen screw with
hex wrench (21). Remove the handle .
Unscrew cap (13) (by hand only). Loosen
the bonnet nut (12) with an adjustable
wrench. Remove the cartridge (11).
Check for cracks.
There is a low flow of water.
The filter washers in the
hose connectors are dirty.
Turn off the water supply at water valve
and unscrew the hose connectors from
the water supply lines. Clean the filter
washers in the water lines with hot water,
removing any debris or calcium build up.