Installation Guide

Connect waterlines (not
included) to hot and cold
copper lines (8). Connect
waterlines (13) to angle
stops. Tighten both ends of
waterlines with a wrench
until snug. Turn on hot and
cold angle stops and check
for leaks
Step 7: Flush spray hose
Step 8: Check for leaks
Remove spray head (1) from
spray hose (5). Hold tip of
spray hose (5). Turn faucet on
and let the water run for 60
seconds to ush any debris
Check for leaks at the
connections. Retighten if
necessary
Step 6: Connect waterlines
NOTE: Please make sure
washer (12) is installed
attaching spray head to hose
5
1
2 3 4 5 6 7
1 2 3
1
3a
2 3 4 5 6 7
1 2 3
1
3a
2 3 4 5 6 7
1 2 3
1
3a