Installation Guide

Leakage under faucet handle
Bonnet nut (7) has
come loose
Remove the cover button (11). Loosen the
screw (10) with the hex wrench (21).
Remove the handle (9). Unscrew the cap
(8) (by hand only). Tighten the bonnet nut
(7) with an adjustable wrench.
Water will not shut
off completely
Cartridge may need to be
adjusted or replaced
Remove the cover button (11). Loosen the
screw (10) with the hex wrench (21).
Remove the handle (9). Unscrew the cap
(8) (by hand only). Loosen the bonnet nut
(7) with an adjustable wrench. Remove the
cartridge (6). Check for cracks.
The aerator has an
irregular or reduced
water flow
The aerator is dirty or
mis-fitted
Remove the aerator and check for debris.
Ensure that the rubber washer is properly
installed.
There is a low flow of
water.
The filter washers in the
hose connectors are dirty.
Turn off the water supply at the water
valves and unscrew the hose connectors
from the water supply lines. Clean the
filter washers in the water lines with hot
water, removing any debris or calcium
build up.
PROBLEM CAUSE ACTION
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly,
take the following corrective steps:
11