Installation Guide

Pull the hose assembly
out of the spout and
remove the spray head by unscrewing it
from the hose in a counterclockwise
direction. Be sure to hold the end of the
hose down into the sink and turn the faucet
on to the warm position where it mixes hot
and cold water. Flush the water lines for one
minute. This flushes away any debris that
could cause damage to internal parts. Check
for leaks. Retighten any connections if
necessary, but do not overtighten. Reinstall
the spray head by hand tightening it back
onto the spray hose.
After installation is complete, turn on the hot
and cold water supplies. Check for leaks.
9
Step 5: Flush faucet