Installation Guide

Weight
here
Weight
here
H
G
A
1
7
Step 3: Installing the counterweight
Step 4: Connect waterlines to main valve
Attach waterlines to angle stops and
tighten until snug. Turn on angle stops
and check for leaks (DO NOT TURN
FAUCET ON).
Install the weight clip (H) at the point of
the hose marking "weight here". Insert
the weight (G) onto the weight clip (H) by
sliding it down onto the weight clip (H).
Step 5: Flush faucet
Pull the hose assembly out of the spout
and remove the spray head (A) by
unscrewing it from the hose in a
counterclockwise direction. Be sure to
hold the end of the hose down into the
sink and turn the faucet on to the warm
position where it mixes hot and cold
water. Flush the water lines for one
minute. This flushes away any debris that
could cause damage to internal parts.
Check for leaks. Retighten any
connections if necessary, but do not
overtighten. Reinstall the spray head (A)
by hand tightening it back onto the spray
hose. After installation is completed, turn
on the hot and cold water supplies.
Check for leaks.
NOTE: Please make sure filter washers
are installed before connecting to the
main valve.
NOTE: Please make sure the washer
(1) is installed before attaching the
spray head to the hose.