Installation & Assembly

Installation Steps
1. Mark faucet and drain hole location
NOTE: Make sure clearance is suitable for backsplash, faucet,
and sink plumbing
NOTE: Use acetone or rubbing alcohol to remove any excess
sealant immediately after application
• Place the sink in the desired location on the countertop and mark
the drain hole and faucet hole centerline with a pencil
• Cut the opening for the drain in the countertop by carefully placing the
4” hole saw on the marked area
• Cut the opening for the faucet in the countertop by carefully placing the
1-3/8” hole saw on the marked area
• Make sure that the sink is aligned to the countertop cutout. Use a
bead of silicone (or preferred adhesive) around the underside of
the sink
• Carefully place the sink on the countertop, align, and press rmly
• Allow sealant to set for 30 – 60 minutes
• Connect drain, drain trap, and water supply connections to the
faucet according to manufacturer’s instructions
• Run water into sink and check for leaks
2. Drill countertop
3. Install sink
4. Install plumbing xtures