User Manual

800-447-8638

Repair Applications

For ½" (13mm)-thick material, align the bottom of the drill

guide with the edge or end of the part to be drilled. For thicker

stock, attach one or more spacer blocks (U) to the drill guide.

Each spacer block accommodates an additional ¼" (6mm)

in material thickness. For example, ¾" (19mm)-thick material

requires one spacer block, 1" (25mm)-thick material requires

two blocks, and 1¼" (32mm)-thick material requires three

blocks. One spacer block is included with your Kreg Jig

Additional blocks are available.

For repair applications, remove the drill guide from the drill

guide socket and clamp it directly to the workpiece.

When using the drill guide separately in a repair application,

remembertosetthestopcollar,andrmlysecurethedrill

guide to the workpiece with a Kreg clamp. In situations where

using a clamp is not possible, you may screw the drill guide

directly to the workpiece, as shown.

Adjusting Clamp Pressure

To increase clamp pressure, turn

the knurled-head screw to the

left (viewed from the handle-end

of the clamp); for less pressure,

turn the screw to the right.

Less

Pressure