Inc. EVOLUTION TWO MONAURAL PREAMPLIFIER OWNER'S MANUAL

continue
d
45
4. Press the enter button or key to confirm the selection. The front panel display
reads:
RS-232 CONTROL.
The right-terminated preamplifier channel is the link transmitter of RS-232 data.
Connect the RS-232 cable to the RS-232 connector on the right-terminated pre-
amplifier channel. For more information on linked preamplifier channels, see
Appendix: CAN Link and Multiple Evolution Two Preamplifiers, on page 51.
Save
This function enables you to save a copy of the current settings. The options are:
GO, BACK.
Enter the menu, then:
1. Use the level control knob on the preamplifier channel front panel or up and
down keys (16) on the remote control to select:
SAVE.
2. Press the enter button on the preamplifier channel front panel or the or enter
key (18) on the remote control. The front panel display (15) shows the default
mode:
GO.
3. Press the enter button or key to save the settings The front panel display
reads:
SAVE.
GO
Saves a copy of current settings to memory, overwriting previously saved settings.
Software Clone
This function enables you to transfer operational softwar
e fr
om one linked pr
eam
-
plifier channel to another
. Software clone insures that, where desired, software for
multiple preamplifier channels is identical. The options are:
NO, YES.
Enter the menu, then:
1. Identify the clone transmitter and clone receiver. The clone transmitter is the
preamplifier channel that transmits the clone and the clone receiver(s) is/are
the preamplifier channel(s) that receive(s) the clone.
2. Use the level control knob on the preamplifier chassis front panel of the clone
transmitter
, or up and down keys (16) on the remote control to select:
SOFTW
ARE
CLONE.
3. Press the enter button on the clone transmitter front panel or the enter key (18)
on the r
emote contr
ol
. The fr
ont panel display (15) r
eads:
SW BEGIN.