Owner manual

48
(SECTION SEVEN: Customizing the Phantom continued)
Tape
This function enables you to configure the tape input as a standard input labeled
S-4. The options are:
TAPE, S-4.
Enter the menu, then:
1. Use the level control knob on the preamplifier front panel or up and down keys
(14) on the remote control to select:
TAPE.
2. Press the enter button on the preamplifier front panel or the enter key (6) on the
remote control
. The front panel display (3) shows the default mode: TAPE.
3. Use the level control knob or the up and down keys to select the desired
option:
Tape or S-4.
4. Press the enter button or key to conirm the selection. The front panel display
reads:
TAPE.
TAPE
The Tape setting maintains standard tape loop functionality with the tape outut.
S-4
Input behaves as an additional single-ended input. Incoming signal sent to tape
output.