Owner’s Manual Seismix 3 and Seismix 5
Congratulations on choosing Krix The Seismix 3 and Seismix 5 active subwoofers will complement existing Stereo or Home Theatre systems producing an increase in low frequency performance for a deep experience. The Seismix 3 and Seismix 5 are compatible with a variety of small to large sized, sealed or vented, main/satellite speakers. Your subwoofer contains an amplifier of the highest electronic standards.
features Automatic on / off circuit Standby Mode Symetrix Vent Clipping protection - Opto-compressor with fast attack to prevent overload - Soft limiting to prevent amplifier clipping Multi-layered fault protection - DC Detect Sensor - Thermal Sensor - Mains Fuse Electronic filtering - Earth lift switch to eliminate ground loops - 2nd order low pass filter adjustable from 60Hz to 150Hz - Adjustable Hi / Lo gain setting - 0°/180° phase switch - Fixed 2nd order high pass filter to reduce driver excursion b
Earth Lift Hi / Lo Gain The Earth Lift button ensures the Seismix can be connected to a wide range of stereo amplifiers / AV receivers. Should a humming noise be evident when the Seismix is connected, push the Earth Lift button (see figure 1) which interrupts the current that may be circulating from the subwoofer’s signal ground through the mains earth wiring (see figure 4).
trouble shooting Volume The volume control will adjust the volume of the subwoofer only. The control can be set for the subtleties of the lower octaves in musical performances or increased for the earth shattering explosions and effects on movie sound tracks. The volume control on your main amplifier / AV receiver controls volume for your overall system (see figure 1).
Seismix 3: specifications Drivers Bass Driver Nominal 255mm (10”) diameter paper cone driver developed for high level, low frequency reinforcement Electronics Amplifier Power 200 watts RMS into the nominal 4 ohm driver Maximum instantaneous power 400 watts Amplifier S/N >70dB Distortion - Input to Speaker <0.
Seismix 5: specifications Drivers Bass Driver Nominal 305mm (12”) diameter paper cone driver developed for high level, low frequency reinforcement and large linear cone travel Electronics Amplifier Power Amplifier S/N Distortion - Input to Speaker Line Level Inputs 400 watts RMS into the nominal 4 ohm driver Maximum instantaneous power 800 watts >70dB <0.
Krix Loudspeakers Pty Ltd 14 Chapman Road Hackham SA 5163 Australia T 61 8 8384 3433 F 61 8 8384 3419 listen@krix.com krix.