User Manual

ManualsBrandsKrix ManualsAudioVolcanix

Due to continued development specifications may change without notice.

Volcanix: specifications

Drivers

Bass Driver

Electronics

Amplifier Power

Amplifier S/N

Distortion

- Input to Speaker

Line Level Inputs

General

Frequency Range

Output

Auto Power On / Off

Phase Select

Filters

Cabinet

Enclosure Type

Dimensions

Material

Finish

Weight

Nominal 305mm (12”) diameter paper cone driver, 50mm long throw

voice coil, developed for high level, low frequency reinforcement

450 watts RMS into the nominal 4 ohm driver

>90dB

<0.1% - @ 400 watts RMS

Left Input (mono) 300mV RMS for maximum output

Left + Right Input (stereo) 150mV RMS for maximum output

16Hz - 200Hz (-6dB) in room response

125dB maximum SPL in room response

15 minute delay before switching to standby after no input signal

0° or 180° (relative to input signal)

Low pass filter 50-195Hz, Bypass

High pass filter to limit driver excursion below 22Hz

Bass reflex, front vented

506mm high x 400mm wide x 470mm deep (including grille and feet)

18mm MDF

Vinyl or lacquered timber veneer

23kg

specification

warranty

5 year warranty applies to the cabinet and

speaker.

2 year warranty applies to the amplifier and

related internal electronics.

(Refer to the details on the warranty card

supplied)

queries

If you have any queries regarding the Tektonix

or Volcanix setup procedure or any other Krix

product, please contact your nearest Krix

retailer or Krix directly. Contact details are on

the back cover of this booklet.

Tektonix: specifications