User guide

Back Panel Features
SYSTEM LEVEL ADJUST
Input sensitivity is adjusted (counterclockwise reduces
sensitivity) through a rear panel mounted trim control.
Adjustment range is from -30dB to +6dB. Factory preset
gain is +6dB, which should suffice for most conditions.
Normally adjustments would only be made if you’re using
your VXT monitors in a surround system and you need to
balance levels or if your monitor-source is too hot and not
adjustable.
HF ADJUSTMENT (VXT 6 and VXT 8 ONLY)
High Frequency Adjustment is through a rear panel mounted 3-position toggle switch.
Range of control is +1dB, Flat, or -1dB shelving above 2 kHz. Factory setting is flat
(toggle switch is in middle position). Room acoustics may dictate which type of adjustment
you need to make to retain the proper frequency response from the monitor.
LF ADJUSTMENT (VXT 6 and VXT 8 ONLY)
This 3-way switch adjusts the low-frequency response of the monitors. Proximity to walls
can add undesirable low frequency content. Adjust the LF Adjustment switch to
compensate for exaggerated low frequency response. Room acoustics may dictate which
type of adjustment you need to make to retain the proper frequency response from the
monitor.
6
The three-way toggle switch provides the ability to adjust the low frequency when the monitors are
effected by by room boundaries such as walls and corner locations. The setting labeled WHOLE
refers to the term "Whole Space" and is used to provide the most bass response. QUARTER refers
to quarter space and rolls off the most low frequencies. HALF refers to "Half Space" and provides a
setting in between no roll off and QUARTER space roll off. Your monitors come from the factory set
to WHOLE space. Read further in this document for more advice on set up.