User Manual

28
4.3.1 How to enter programming mode
To start:
Display Comments
→ Press Fct. 1.0
Operation
or
If this appears, see next box: ”Function of the keys ” .
CodE 1
---------
If this appears on the display, set the 9-keystroke Entry
CodE 1 .
Factory setting: → → → ↵ ↵ ↵ ↑ ↑ ↑
1
st
- 8
th
place
(key)
CodE 1
∗∗∗∗∗∗∗∗-
Each keystroke acknowledged by " ∗ " in display.
9
th
place
(key)
Fct. 1.0
Operation
If this appears, see box: ”Function of the keys ” below.
CodE 1
(9 alpha
characters)
A wrong Entry CodE 1 was keyed in. Press any key and set
the correct 9-keystroke
4.3.2 How to terminate Programming mode
To terminate:
Press ↵ 1-3
times
Fct (1).0
OPERATOR
Press ↵ 1-3 times until the cursor is under the extreme
left menu column. (Fct. 1.0 , 2.0 or 3.0)
↵ + 12.345
kg/min
or
If no changes have been made to the system’s configu-
ration return directly to the measurement mode.
(ACCEPT YES) Changes have been detected. Press ↵ to accept these
changes.
or
↑
(ACCEPT NO)
Press ↵ to reject changes and return directly to
measurement mode.
or
↑
(GO BACK)
Press ↵ to return to the menus, Fct. 1.(0) to make
further changes
↵ PARAM.CHECK Assuming ACCEPT YES was selected,
the system now checks the new setting for errors.
After 1-2 sec. + 12.345
kg/min
No errors detected. Return to measurement mode.
or
Fct. (4).0
PARAM.ERROR
Errors were detected. The sub-menus of 4.0 will guide
the operator to those functions where problems have
been identified.