User Manual

49
For systems with concentration software their specific extra displays will be added to the above
list from Fct. 1.2.9 onwards.
The displayed measurement function can be changed in the measurement mode by pressing ↑
key.
The setting of the display output is demonstrated for the example of displaying the mass flow
rate in kg/h.
Starting from the display of measurement values, the following programming steps are
necessary.
Begin from measuring mode.
After pressing → key the display shows :
0000.0000 (kg)/min
This display means that mass flow will be displayed in units of kg/min to an accuracy of 4
decimal places.
The brackets around 'kg' indicate the cursor position, these characters will be flashing on the
display. The flashing value can now be changed with the ↑ key. By pressing the → key the
cursor moves to 'min' which starts to flash.
This dimension may now also be changed by using the ↑ key. After pressing the → key again,
the cursor moves to the output format of the numeric value which can then be edited.
To change the display to kg/h with 5 decimal places, follow the following procedure.
Key Display
line 1 line2
→ Fct. (1).0 OPERATOR
2x↑ Fct. (3).0. INSTALL
→ Fct. 3.(1).0. BASE DATA
↑ Fct. 3.(2).0. DISPLAY
→↑↑ Fct. 3.2.(3). MASS FLOW
Key Display
line 1 line 2
0000.0000 (kg)/min
→ 0000.0000 kg/(min)
↑ 0000.0000 kg/(h)
→ 0000(.)0000 kg/h
↑ 00000(.)000 kg/h
↑ 000000(.)00 kg/h
↑ 0000000(.)0 kg/h
↑ 00000000(.) kg/h
↑ 0(.)0000000 kg/h
↑ 00(.)000000 kg/h
↑ 000(.)00000 kg/h
↵ Fct. 3.2.(3).
MASS FLOW