User Manual

50
The setting of the display for TOTAL MASS or DENSITY is done the same way.
Temperature is displayed with a fixed position of one decimal place. However, the user can
choose between °C and °F.
Begin from measuring mode
Volume flow is an optional display in the measurement mode. To turn on this display with units
dm3/hr :
For a list of available units for each display refer to Section 5, Technical data.
If a cyclic display of all measurement values is desired the following inputs have to be added to
the previous steps :
With the cyclic display enabled, the converter will switch displays in the measuring mode every
3 to 4 seconds as if the operator had pressed the ↑ key.
Key Display
line 1 line 2
→ Fct. (1).0 OPERATOR
→↑ Fct. 1.(2).0. DISPLAY
5x↑ Fct. 1.2.(6). TEMPERATUR
→ (°C)
↑ (°F)
↵ Fct. 1.2.(6). TEMPERATUR
Key Display
line 1 line 2
↑ Fct. 1.2.(7) VOL.FLOW.
→ (OFF)
↑ 00000.000 (cm3)/S
↑ 00000.000 (dm3)/S
→↑↑ 00000.000 dm3/(hr)
→ 00000(.)000 dm3/ hr
↑↑ 0000000(.)0 dm3/hr
↵ Fct. 1.2.(7) VOL.FLOW
Key Display
line 1 line 2
↵→ Fct. 1.2.(1). CYCL. DISP.
→ (NO)
↑ (YES)
↵ Fct. 1.2.(1). CYCL. DISP.
4x↵