User Manual

6 OPERATION
80
OPTIWAVE 7400-24 C
www.krohne.com 12/2015 - 4004901901 - MA OPTIWAVE7400-24 R01 fr
— Empty Spectrum
Invalid
5 The empty spectrum stored in
the device does not agree with
the installation. If you change
the device configuration (tank
height etc.), this message will
be shown. The recorded empty
spectrum will not be used by
the device while this error
message is shown.
1
Record a new empty spectrum.
Follow the instructions on page
75.
— Signal Weak 4 The signal amplitude is less
than the average value. This can
occur if the liquid is agitated or
if there is foam in the tank. If
this error occurs frequently, the
device will possibly show the
"Peak Lost (Level Lost)" error
message.
1
If this error occurs frequently, it
is possible that you must install
the device in a stilling well or
use a different antenna type.
— Signal Strong 4 This error can occur if there is a
large change in signal
amplitude.
1
No corrective action is
necessary.
— Bad Measurement
Quality
4 The measurement is incorrect
and continues to be incorrect
after more than 10 s. This error
can occur if the tank contents
are immediately below the
antenna. 1
Record the process with the
PACTware™ software tool to
find the cause of the problem. If
necessary, speak to the
supplier.
— Temperature <-
35°C/ -31°F
3 The process connection or the
ambient temperature is less
than -35°C/ -31°F. This
temperature is near to the
minimum limit for device
operation.
1
Measure the ambient
temperature. De-energize the
device until the ambient
temperature is back in the given
range. If the temperature does
not stay in the correct range,
make sure that there is
insulation around the signal
converter.
— Temperature
>+75°C / +167°F
3 The ambient temperature is
more than +75°C / +167°F. This
temperature is near to the
maximum limit for device
operation.
1
Measure the ambient
temperature. De-energize the
device until the ambient
temperature is back in the given
range. If the temperature does
not stay in the correct range,
make sure that there is
insulation around the signal
converter.
1 This error message does not have an effect on the current output signal
Error
code
Error Message Status marker
shown
Cause Corrective action