Manual

3 INSTALLATION
34
OPTIFLEX 2200 C/F
www.krohne.com 07/2013 - 4000668002 - HB OPTIFLEX 2200 R02 en
• Attach a lock nut to the threaded rod below the process connection. Turn the nut until it is ¾
along the length of the rod.
• Attach a union nut to the threaded rod below the process connection.
• Use two 8 mm open-end wrenches to tighten the union nut against the lock nut.
Figure 3-27: How to assemble the segmented single rod probe: part 1
CAUTION!
Make sure that the nuts are tight and the rod probe cannot loosen.