Quickstart EN Owner's manual

INSTALLATION 2
21
OPTIFLEX 2200 C/F
www.krohne.com08/2013 - 4000622103 - QS OPTIFLEX 2200 R03 en
• Attach a lock nut to the threaded rod below the process connection. Turn the nut until it is ¾
along the length of the rod.
• Attach a union nut to the threaded rod below the process connection.
• Use two 8 mm open-end wrenches to tighten the union nut against the lock nut.
Figure 2-23: How to assemble the segmented single rod probe: part 1
CAUTION!
Make sure that the nuts are tight and the rod probe cannot loosen.