Quickstart EN Owner's manual

2 INSTALLATION
30
OPTIFLEX 2200 C/F
www.krohne.com 08/2013 - 4000622103 - QS OPTIFLEX 2200 R03 en
2.10.8 Recommendations for pits and tanks made of non-conductive materials
If you have a device with a single rod or a single cable probe and a thread connection,
obey these instructions:
• Put a metal sheet between the device and the process connection.
i It must have a diameter greater than 200 mm / 8¨.
• Make sure that the metal sheet is in contact with the thread stop on the device.
We recommend that you use DN≥200 / ≥8¨ for flange connections.
If you have a device with a double rod, double cable or coaxial probe, you can ignore these
instructions.
Figure 2-34: Installation in a non-metallic tank or pit with a thread connection
1 Non-metallic (plastic...) tank or pit
2 Metal sheet, Ø ≥200 mm / 8¨
CAUTION!
When the device is installed, make sure that the tank roof has no deformation.