User guide

5 OPERATION
56
OPTISYS SLM 2100
www.krohne.com 03/2014 - 4002737302 - MA OPTISYS SLM 2100 R02 en
Step 3: calibrate zero
The calibration zero is done.
• Press ^
^^
^ several time until you reach the measuring mode again. Choose yes
yesyes
yes to safe and
confirm your selection.
Step 3a: calibrate conc. with known reference value
Press 

 or 

 until the submenu calibrate zero
calibrate zerocalibrate zero
calibrate zero is highlighted.
Press >
>>
> to enter the chosen menu.
actual value
actual valueactual value
actual value is shown.
Press ^
^^
^ to enter the chosen menu.
calibrate zero
calibrate zerocalibrate zero
calibrate zero is shown.
Press 

 or 

 to select calibrate
calibratecalibrate
calibrate to calibrate or break
breakbreak
break to interrupt the calibration.
Press ^
^^
^ to enter the chosen menu.
Start the calibration process with step 2: move sensor
Press 

 or 

 until the submenu calibrate conc.
calibrate conc.calibrate conc.
calibrate conc. is highlighted.
Press >
>>
> to enter the chosen menu.
reference value
reference valuereference value
reference value is shown.
Press 

 or 

 to enter the reference value.
Press ^
^^
^ to confirm the value.
ADC value
ADC valueADC value
ADC value is shown.
Press 

 or 

 to choose between stored value
stored valuestored value
stored value to use the stored value or actual value
actual valueactual value
actual value to use
the actual value for calibration.
Press 

 or 

 to select actual value
actual valueactual value
actual value.
Press ^
^^
^ to enter the chosen menu.
actual value
actual valueactual value
actual value is shown.
Press ^
^^
^ to confirm the value.
use value
use valueuse value
use value is shown.
Press 

 or 

 to choose between break
breakbreak
break to interrupt the calibration,calibrate
calibratecalibrate
calibrate
to adjust the actual value to the reference value or save ADC value
save ADC valuesave ADC value
save ADC value to save
the actual value.
Press 

 or 

 to select calibrate
calibratecalibrate
calibrate
Press ^
^^
^ to enter the chosen menu.
Press ^
^^
^ several time until you reach the measuring mode again.
Choose yes
yesyes
yes to safe and confirm your selection.
.book Page 56 Wednesday, April 30, 2014 1:39 PM