Manual
TECHNICAL DATA 8
103
OPTIWAVE 5200 C/F
www.krohne.com07/2013 - 4001904902 - HB OPTIWAVE 5200 R02 en
Pressure
PressurePressure
Pressure
Process pressure PP Wave Horn antenna:
PP Wave Horn antenna:PP Wave Horn antenna:
PP Wave Horn antenna:
-1…16 barg / -14.5…232 psig. For more data, refer to
Pressure ratings
on page
109.
PTFE Wave Horn antenna:
PTFE Wave Horn antenna:PTFE Wave Horn antenna:
PTFE Wave Horn antenna:
-1…40 barg / -14.5…580 psig. For more data, refer to
Pressure ratings
on page
109.
Metallic Horn antenna / Wave Guide antenna:
Metallic Horn antenna / Wave Guide antenna:Metallic Horn antenna / Wave Guide antenna:
Metallic Horn antenna / Wave Guide antenna:
Standard: -1…40 barg / -14.5…580 psig;
subject to the process connection used and the flange temperature. Higher
pressure on request.
Purging system (option) Max. 6 barg / 87 psig (higher pressure on request)
Heating / cooling system (option) Max. 6 barg / 87 psig (higher pressure on request)
Other conditions
Other conditionsOther conditions
Other conditions
Dielectric constant (ε
r
) Direct mode: ≥1.8
TBF mode: ≥1.1
Refer also to "Technical data: Antenna selection".
Ingress protection IEC 60529: IP 66/67
NEMA 250: NEMA type 4X (housing) and type 6P (antenna)
Maximum rate of change 10 m/min / 32.8 ft/min
Installation conditions
Process connection size The nominal diameter (DN) should be equal to or larger than the antenna diameter.
Process connection position Make sure that there are not any obstructions directly below the process
connection for the device. For more data, refer to
Installation
on page 19.
Dimensions and weights For dimensions and weights data, refer to
Dimensions and weights
on page 116.
Materials
Housing Standard: Polyester-coated aluminium
Option: Stainless steel (1.4404 / 316L)
Antenna options / Wetted
materials
PTFE Wave Horn antenna with a PTFE flange cladding
PP Wave Horn antenna with a PP jacket/threaded process connection
Stainless steel (1.4404 / 316L) Metallic Horn antenna with a PTFE process seal and
an FKM/FPM, EPDM, Kalrez® 6375 or PFA O-ring gasket
Stainless steel (1.4404 / 316L) Wave Guide antennas with a PTFE process seal and
an FKM/FPM, EPDM, Kalrez® 6375 or PFA O-ring gasket
Feedthrough PP Wave Horn antenna: this is a single-piece antenna (the feedthrough is filled with
PP)
PTFE Wave Horn antenna: this is a single-piece antenna (the feedthrough is filled
with PTFE)
Metallic Horn and Wave Guide antennas: Dual process seal system - 1st seal: PTFE
with O-ring gasket , 2nd seal: Metaglas® with O-ring gasket 2
Cable gland Standard: none
Options: Plastic (Non-Ex: black, Ex i-approved: blue); nickel-plated brass; stainless
steel
Weather protection (Option) Stainless steel (1.4404 / 316L)