Owner's manual

User Guide for Optiwave (FMCW) DD of AMS
Dev Rev-01, DD Rev-02
© 2006 KROHNE SAS 26103 Romans (France) Page 33 of 34
4 Status Meaning
Status Message Meaning
Supervisor Password OK Entered password for Supervisor rights is
correct.
Supervisor Password Invalid Entered password for Supervisor rights is
incorrect.
Simulation Service Password OK Entered password for Service rights in
Simulation mode is correct.
Service Password Invalid Entered password for Service rights is
incorrect.
Service Password OK Entered password for Service rights is
correct.
Simulation Supervisor Password OK Entered password for Supervisor rights in
Simulation mode is correct.
Dependency failure It appears if the dependency of the
parameter being modified is failed.
Update not possible It appears if read only parameter is
modified.
Reading data from device It appears when the entries of table being
read by the device.
Dependency Warning Message It appears if the variable is modified and is
dependent on other variables. Such
scenario could violate its normal operation.
Max range failure When the entered value is more than its
maximum allowed value.
Min range failure When the entered value is less than its
minimum allowed value.
Table entered is not monotonous If the entered value is less than the next
entry.
Device busy
Appears when the device is busy. Normally
it appears when the device is in search
mode or if it is executing a function.
Access Restricted
This message appears if we try to modify a
read only parameter.
Invalid Section You have selected a non valid item.
Too Few Bytes Received There are not enough bytes received.
Invalid Command Request Requested command is invalid.
Value out of range This occurs if the entered value is out of
range for that parameter.
Exceed precision If the decimal value entered exceeds its
range.