Instruction Manual

6 OPERATION
38
UFM 530 HT
www.krohne.com 12/2013 - 4002393201- HB UFM 530 HT R02 en
Test functions menu
No. of menu Display text Setting/description and functions
This menu is for testing the display, the in- and outputs and for information on hard- and software
numbers.
2.01.00, DISPLAY
2.01.01 DISPLAY Test display, lights all pixels (end with ^ key).
2.02.00, OUTPUTS
2.02.01 CURRENT Test current output (0, 4, 12, 20 and 22 mA).
Use ↑ key to go to next value. Displayed value directly present at
current output. End with ^ key.
2.02.02 PULSE Test pulse/frequency output (1, 10, 100, 1000 and 2000 Hz).
Use ↑ key to advance. Displayed value directly present at pulse
output. End with ^ key.
2.03.00, INPUTS
2.03.01 AN INP 1 Test analog input 1.
Measure current at analog input 1.
End with ^ key.
2.03.02 AN INP 2 Test analog input 2.
Measure current at analog input 2.
End with ^ key.
2.03.03 DIG INPUT Test digital input. Measure level at digital input.
End with ^ key.
2.03.04 SENSOR Sensor status: good, open, short
2.04.00, DEV INFO (Device information)
2.04.01 MANUFACT Display manufacturer.
2.04.02 MODEL NO Display model number.
2.04.03 SERIAL NO Display serial number.
2.04.04 UP2 HW NO Display μP2 hardware number.
2.04.05 UP2 SW NO Display μP2 software number.
2.04.06 FRNT HW NO Display front end hardware number.
2.04.07 DSP HW NO Display D.S.P. hardware number.
2.04.08 DSP SW NO Display D.S.P. software number.
2.04.09 TIME COUNT Display time counter.